The compact Simply Servo board for Raspberry Pi Pico allows simultaneous control of up to 8 servos, making it ideal for advanced robotics projects with the RiPi Pico. The board should be used with a Pico that has soldered terminal heads, the Pico can then be mounted directly to the board. The board has standard 3-pin servo sockets, which allow the servos to be connected directly without the need for adapting or soldering Notes: This board does not come with a Raspberry Pi Pico This board is capable of continuous use at high currents. During such use, it may heat up Due to the additional power consumption of the Pico W’s wireless functions, it is not recommended to use wireless operation with this board. The standard functionality of the Pico W will operate normally only the wireless functions are affected Features: Control up to 8 servos simultaneously with the Raspberry Pi Pico Up to 100 hours of high-speed, high-powered I/O with up to 150 Pico functions. The board features standard 3-pin servo slots The board also features 5 external connections to GPIO pins and 3V and GND power from the Pico. These IOs separate the 3 ADC pins and GP0 and GP1 The board has a power input terminal with pin block, with on/off switch and power status LED The board will power all connected servos and provide the connected Pico with an adjustable 3V power supply In addition, there is built-in reverse polarity protection A Raspberry Pi Pico with attached headersis required