The Simple Servo Control Board offers a simple interface between the BBC micro:bit and up to 3 servos. The board has a terminal for the micro:bit connector and in addition to the servo head connections, there are also 6 terminals that can allow additional devices to be connected The servo header connections are in 0.1 inch pitch and are marked on the board as power, ground and signal. The 6 croc-clippable pads, at the bottom of the board, detach the P0, P1, P2 pins from the micro:bit. There are also pads for 3.3V and GND, with the last pad (Switch A) allowing an external switch to be connected Features: A simple interface for the BBC micro:bit, to control up to 3 servos It has a terminal that the micro:bit is pushed into it In addition to the servo terminal connections, there are also 6 croc-clippable pads for adding additional devices The board includes a power switch to turn the BBC’s servos and micro:bit on or off The power LED on the top of the board indicates when the board is active Code it with MakeCode and MicroPython The board has mounting tabs on each side. They are designed for use with rubber bushings, so the board can be attached to your project without the need for tools The simple servo control board has a battery compartment on the back of the board Requires: BBC micro:bit 3x AA batteries USB cable USB servo drives, any combination of: 360 degree continuous rotation servo motor 180 degree servo motor 180 degree servo gear